MANA DT SMA
It is the combination of the previous IR section and the MW section described later, typically consisting of a pair of columns, where one houses all the transmitting components, including a TX microwave and 4 TX beams, and the other houses all the receiving components, including a RX microwave and the 4 active RX infrared beams.
The TX column, although it only has the output related to the column tamper, is connected to the bus to continuously provide notifications and any technical anomalies, such as power, temperature, etc. On the RX column, where all the alarm outputs related to the infrared section are present, in addition to the technical notifications, the microwave alarm output is connected to one of the three inputs on the terminal block board. The microwave alarm is then transmitted via bus to the ADEBUS board, where it will be assigned an alarm relay to be triggered on a separate input of the alarm control panel.
- It is the combination of the infrared and microwave sections that form the pair of columns, typically TX and RX.
- MANA DT SMA can be connected to the RS485 bus and managed by the centralized ADEBUS system.
- Independent outputs from the two sections allow for the management of the alarm control panel, ensuring the continuous operation of the system in both critical environmental and climatic conditions.
- New junction box for mounting with a customizable cable entry that helps reduce space while preventing the ingress of moisture and foreign objects.
- Each section has its own alarm outputs, which can be managed as desired depending on the requirements (OR or AND).
- The microwave alarm is transmitted via bus to the ADEBUS board, where it will be associated with an alarm relay to be triggered on a separate input of the alarm control panel.
Per model
Request info
Fill out our form to receive more information about the product.
Error: Contact form not found.
Contact Us
- Via Adda, 64 - 20882 Bellusco (MB)
- info@politecgroup.it
- 039 688 30 19
